Pocket Door Handle Installation

Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw.

Pocket door handle installation.

To use the locking lever turn the lever which is on the lock body at the side. Measure up 36 inches from the floor. Jun 23 2020 explore hartford bldg prod s board pocket door hardware on pinterest. You can install the door pull on any pocket door that s been previously installed.

Place a mark where this lever comes into contact with door jamb. The pocket door is to be closed almost all the way. Check that the track is level so that the door rolls easily. Then cut the exposed studs to make room for the new framing.

Step 2 position pocket door pull. 1 pull the door halfway open by grasping the edge of it with your fingertips. Step 1 read the directions. Use your pencil to mark the jamb of the door for the latch plate to be installed.

Drill the mounting screw holes. Door knobs pulls lock sets other accessories hardware installation instructions and manuals resources from emtek products inc. How to install your pocket door hardware in 5 steps. Step 4 drill holes.

Trace the lever outline on the door s edge. Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door. To install a pocket door start by removing the existing door and the drywall on one side of the wall. Be sure to screw the brackets into the studs.

Step 3 mark the screw points. Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives. See more ideas about pocket door hardware pocket doors door hardware. Nail the end plate to the wall studs.

Next install the slider track using the rails that came in your pocket door kit. Then put the hardware and door into the slider track. Mark the spots for the mounting screws using an awl.