Pocket Door Hardware Instructions

High and 1 3 4 in.

Pocket door hardware instructions.

Purchase a pocket door kit at a hardware store. Install the track according to the thickness of the header. Nail the end plate to the wall studs. The everbilt 36 in.

If needed use a hand saw to cut the track that came with your pocket door hardware so that it s 1 8 inch shorter than the opening. Make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives. This kit should contain the door split studs that allow the door to retract into the wall a track on which the door runs into the wall and door hardware. 1 574 293 5664 m f 8 00am 5 00pm est.

Attach the split studs to the floor and to the header checking for plumb. Répétez l opération avec l autre roulette et attache de porte. Vertically and the door rough opening should be 4 in. Its door panels are adjustable up to 5 8 in.

Bumpers pads slides door hardware home hardware household hangers knobs pulls. Pocket door frame set is designed for use with doors up to a maximum of 80 in. Item 264668 model n 7015n 7015. Check that the track is level so that the door rolls easily.

Door hardware knobs pulls supports catches latches all categories. Higher than the door panel height. Step 1 read the directions. Johnson hardware pocket door hardware.

Fasten split header on 1121 lock lever side with screws for future door removal or adjustment. Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw. Most are under 100. Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased.

The door rides through a channel made by what are called split studs these studs function like regular wall studs but are metal wrapped and form a hollow channel in the middle for the pocket door to pass through. Do not use jambs with dado s. For doors inch thick install the track flush with the header. Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door.

Once the frame is in place it s time for the pocket door installation. Pocket door frame set the everbilt 36 in.